ASTM D5948 - 05(2012) - Standard Specification for Molding Compounds, Thermosetting

ASTM D5948 - 05(2012)

Standard Specification for Molding Compounds, Thermosetting

Status : Current   Published : January 2012



1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.

1.2  Classification—Molding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see 5.1 and Annex A1-Annex A8).

[This table has been removed.]

Note 1There is no equivalent ISO standard.

1.3  Order of Precedence—In the event of a conflict between the text of this specification and the references cited in Section 2 (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

1.4 The values stated in SI units are to be considered standard.

Standard NumberASTM D5948 - 05(2012)
TitleStandard Specification for Molding Compounds, Thermosetting
Publication Date10 January 2012
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Diallyl phthalate plastics, Epoxy plastics, Melamine-formaldehyde plastics, Molding compounds, Phenolic plastics, Plastics, Polyester plastics, Silicone resin molding compounds
File Size161.6 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


The faster, easier way to work with standards

Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version

Develop a PAS

Develop a fast-track standardization document in 9-12 months