ASTM D5750/D5750M - 95(2012) - Standard Guide for Width and Length of Pressure-Sensitive Tape

ASTM D5750/D5750M - 95(2012)

Standard Guide for Width and Length of Pressure-Sensitive Tape

Status : Current   Published : January 2012



1.1 This guide provides guidelines for widths and lengths of pressure-sensitive tape, including tolerances and labeling in the inch-pound and SI systems. It is not intended for tapes used for medical, surgical, or label stock purposes.

1.2 Units stated in the inch-pound system followed by a calculated unit in the SI system are to be regarded separately as standard and should not be interchangeable with units stated in the SI system. The units stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard NumberASTM D5750/D5750M - 95(2012)
TitleStandard Guide for Width and Length of Pressure-Sensitive Tape
Publication Date04 January 2012
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Inch-pound, Length, Pressure-sensitive tape, SI, Width, Length, Pressure-sensitive tapes, Tape, Width
File Size57.41 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents

Worldwide Standards
We can source any standard from anywhere in the world

Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


The faster, easier way to work with standards