BS ISO 8434-6:2009 Metallic tube connections for fluid power and general use. 60° cone connectors with or without O-ring
BS ISO 8434-6 specifies general and dimensional requirements for the design and performance of 60° cone connectors and braze-on nipples with or without O-ring sealing, made of steel for tube outside diameters of 6 mm through 50 mm, inclusive, or hose sizes 5 through 51, inclusive. These connectors are for use in fluid power land general applications within the limits of pressure and temperature specified in this part of ISO 8434.
They are intended for the connection of tubes and hose fittings to ports in accordance with ISO 6149-1 and ISO 1179-1. See ISO 12151-6 for related hose fitting specification.
These connectors provide full-flow connections in hydraulic systems operating to the working pressures shown in Table 1.
Contents of BS ISO 8434-6:
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Materials
4.1 General
4.2 Connector bodies
4.3 Nuts
4.4 O-rings
5 Pressure/temperature requirements
6 Designation of connectors
7 Requirements for tubes
8 Across-flats dimensions and tolerances
9 Design
9.1 Connectors
9.2 Dimensions
9.3 Passage tolerances
9.4 Angular tolerances
9.5 Contour details
9.6 Ports and stud ends
10 Screw threads
10.1 60° cone connection ends
10.2 Stud ends (connection ends
11 Manufacture
11.1 Construction
11.2 Workmanship
11.3 Finish
11.4 Connector protection
11.5 Corners
12 Assembly instruction
13 Procurement information
14 Marking of components
15 Performance and qualification test
15.1 Performance requirements
15.2 Test data form
16 Identification statement (reference to this part of ISO 8434)
Annex A (informative) Preferred thread undercut details when bonded washer type seal is used
Bibliography