ASTM D619 - 14 - Standard Test Methods for Vulcanized Fibre Used for Electrical Insulation

ASTM D619 - 14

Standard Test Methods for Vulcanized Fibre Used for Electrical Insulation

Status : Current   Published : January 2014



1.1 These test methods cover the procedures for testing vulcanized fibre sheets, tubes, and rods of such grades as can be used for electrical insulation.

1.2 The procedures appear in the following sections:

[This table has been removed.]

1.3 The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are for information only.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 7.3, 22.1, 22.2.

Note 1:  The test methods described herein are similar technically to those described in IEC Publication 60667-2. Not all of the tests in this document are included in IEC 60667-2, and the procedures in the two publications are not completely identical; but it is expected that comparable results will be obtained from most of the procedures. Conduct comparative tests if necessary before directly comparing results of tests using the different procedures.

Standard NumberASTM D619 - 14
TitleStandard Test Methods for Vulcanized Fibre Used for Electrical Insulation
Publication Date11 January 2014
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Arc resistance, Ash content, Bond strength, Bursting strength, Compressive strength, Density, Dielectric strength, Flame resistance, Flexural strength, Impact resistance, Inside diameter, Outside diameter, Ply adhesion, Rigid rods, Rigid sheets, Rigid tubes, Rockwell hardness, Silica content, Tear resistance (internal), Tensile strength, Thickness, Volatile content, Vulcanized fibre, Wall thickness, Water absorption, Zinc chloride content
File Size118 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents

Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version

Develop a PAS

Develop a fast-track standardization document in 9-12 months

Worldwide Standards
We can source any standard from anywhere in the world