BS EN 61000-4-4:2004+A1:2010 - Electromagnetic compatibility (EMC). Testing and measurement techniques. Electrical fast transient/burst immunity test – BSI British Standards

BS EN 61000-4-4:2004+A1:2010

Electromagnetic compatibility (EMC). Testing and measurement techniques. Electrical fast transient/burst immunity test

Status : Revised, Withdrawn   Published : February 2005 Replaced By : BS EN 61000-4-4:2012

WITHDRAWN TITLE
*To ask about withdrawn titles contact the
Customer Relations
cservices@bsigroup.com, +44 345 086 9001


BS EN 61000-4-4:2004+A1:2010 Electromagnetic compatibility (EMC). Testing and measurement techniques. Electrical fast transient/burst immunity test

BS EN 61000-4-4 cover the immunity of electrical and electronic equipment to repetitive electrical fast transients.

It gives immunity requirements and test procedures related to electrical fast transients/bursts. It additionally defines ranges of test levels and establishes test procedures.

BS EN 61000-4-4 establishes a common and reproducible reference for evaluating the immunity of electrical and electronic equipment when subjected to electrical fast transient/bursts on supply, signal, control and earth ports. The test method documented in BS EN 61000-4-4 describes a consistent method to assess the immunity of an equipment or system against a defined phenomenon.

As described in IEC Guide 107, this is a basic EMC publication for use by product committees of the IEC.

As also stated in Guide 107, the IEC product committees are responsible for determining whether this immunity test standard should be applied or not, and if applied, they are responsible for determining the appropriate test levels and performance criteria. TC 77 and its sub-committees are prepared to co-operate with product committees in the evaluation of the value of particular immunity tests for their products.

BS EN 61000-4-4 defines:

– test voltage waveform;
– range of test levels;
– test equipment;
– verification procedures of test equipment;
– test set-up;
– test procedure.

The standard gives specifications for laboratory and post-installation tests.

Contents of BS EN 61000-4-4:

Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General
5 Test levels
6 Test equipment
6.1 Burst generator
6.2 Coupling/decoupling network for a.c./d.c. mains supply port
6.3 Capacitive coupling clamp
7 Test set-up
7.1 Test equipment
7.2 Test set-up for type tests performed in laboratories
7.3 Test set-up for post-installation tests
8 Test procedure
8.1 Laboratory reference conditions
8.2 Execution of the test
9 Evaluation of test results
10 Test report
Annex A (informative) Information on the electrical fast transients
Annex B (informative) Selection of the test levels
Bibliography

 




Standard NumberBS EN 61000-4-4:2004+A1:2010
TitleElectromagnetic compatibility (EMC). Testing and measurement techniques. Electrical fast transient/burst immunity test
StatusRevised, Withdrawn
Publication Date02 February 2005
Withdrawn Date31 May 2015
Normative References(Required to achieve compliance to this standard)IEC 60050-161:1990
Informative References(Provided for Information)IEC 61000-4-4:1995, IEC 60050-300:2001
Replaced ByBS EN 61000-4-4:2012
ReplacesBS EN 61000-4-4:1995, IEC 61000-4-4:1995
International RelationshipsIEC 61000-4-4:2004/AMD1:2010,EN 61000-4-4 Amd 1 (03/10) IEC
Amended ByAMD 16840
Amendment, May 2010; Corrigendum, April 2008
Draft Superseded By09/30202398 DC
DescriptorsElectromagnetic radiation, Electrical testing, Verification, Electronic equipment and components, Laboratory testing, Electrical equipment, Transient voltages, Circuits, Electromagnetic fields, Electric power system disturbances, Noise (spurious signals), Electromagnetic compatibility
ICS33.100.20
Title in FrenchCompatibilité électromagnétique (CEM). Techniques d'essai et de mesure. Essais d'immunité aux transitoires électriques rapides en salves
Title in GermanElektromagnetische Verträglichkeit (EMV). Prüf- und Messverfahren. Prüfung der Störfestigkeit gegen schnelle transiente elektrische Störgrößen/Burst
CommitteeGEL/210/11
ISBN978 0 580 67578 2
PublisherBSI
FormatA4
DeliveryNo
Pages36
File Size997 KB
Price£214.00


WITHDRAWN TITLE
*To ask about withdrawn titles contact the
Customer Relations
cservices@bsigroup.com, +44 345 086 9001
 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


BSOL

The faster, easier way to work with standards


Worldwide Standards
We can source any standard from anywhere in the world


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Customers who bought this product also bought

  • BS EN 61000-4-3:2006+A2:2010
    Electromagnetic compatibility (EMC) Testing and measurement techniques. Radiated, radio-frequency, electromagnetic field immunity test
  • BS EN 61000-4-2:2009
    Electromagnetic compatibility (EMC) Testing and measurement techniques. Electrostatic discharge immunity test
  • BS EN 61000-4-8:2010
    Electromagnetic compatibility (EMC) Testing and measurement techniques. Power frequency magnetic field immunity test
  • BS EN 61000-6-4:2007+A1:2011
    Electromagnetic compatibility (EMC) Generic standards. Emission standard for industrial environments