BS ISO 10332:2010 Non-destructive testing of steel tubes. Automated ultrasonic testing of seamless and welded (except submerged arc-welded) steel tubes for verification of hydraulic leak-tightness
BS ISO 10332 is an International Standard which specifies requirements for automated ultrasonic shear-wave (generated by single element probes or the phased-array technique) testing of seamless and welded (except submerged arcwelded) steel tubes, for verification of hydraulic leak-tightness.
The testing technique is applied for the detection of predominantly longitudinal imperfections.
Where applicable, Lamb-wave testing may be applied at the discretion of the manufacturer.
This International Standard is applicable to the inspection of tubes with an outside diameter greater than or equal to 10 mm, and with an outside diameter-to-thickness ratio greater than or equal to 5.
Contents of BS ISO 10332:
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Method of test
6 Reference tube
6.1 General
6.2 Types of reference notches
6.3 Dimensions of reference notches
6.3.1 Width, w
6.3.2 Depth, d
6.3.3 Notch length
6.4 Reference hole
6.5 Verification of the reference standards
7 Equipment calibration and checking
7.1 General
7.2 Adjustment of the trigger/alarm level
7.3 Calibration check and re-calibration
8 Acceptance
9 Test method
Annex A (normative) Manual/semi-automated testing of untested ends and suspected areas