BS EN 754-8:2008 Aluminium and aluminium alloys. Cold drawn rod/bar and tube. Porthole tubes, tolerances on dimensions and form
BS EN 754-8 is the European Standard document and part of the BS EN 754 series, that specifies the tolerances on dimensions and form for aluminium and aluminium alloy cold drawn porthole tubes with an outside diameter (OD) from 3 mm to 350 mm (round tube) or with a cross section contained within a circumscribing circle (CD) from 8 mm to 300 mm (other than round tube), supplied in straight lengths.
This document only applies to cold drawn tube for general engineering applications made in the following alloys:
- EN AW-1050A, EN AW-1200
- EN AW-3003, EN AW-3103
- EN AW-5005, EN AW-5005A, EN AW-5049, EN AW-5251, EN AW-5052
- EN AW-6012, EN AW-6060, EN AW-6061, EN AW-6262, EN AW-6262A
- EN AW-6063, EN AW-6063A, EN AW-6065, EN AW-6082
- EN AW-7020.
The temper designations used in this part are according to BS EN 515.
This document only applies to tube produced by the porthole/bridge method of extrusion only (and then cold drawn to the final dimensions).
This document does not apply to:
Cold drawn tubes produced by the seamless, die/mandrel method (EN 754-7)
Tubes delivered in coils (EN 13958)
Coiled tubes cut to length (EN 13958).
Contents of BS EN 754-8 include:
- Foreword
- Scope
- Tolerances on dimensions
- Diameter - Round tube
- Width, depth or width across flats - squares, rectangles, hexagons, octagons
- Wall thickness variation (eccentricity)
- Length
- Squareness of cut ends
- Tolerances on form
- Straightness
- Convexity–Concavity
- Twist
- Angularity
- Corner and fillet radii
- Depth of dents for round tubes
- Wall thickness variation (eccentricity)
- Specifying round tube sizes and tolerances
- Wall thickness variation for tubes
- Bibliography
BS EN 754-8:2008 supersedes BS EN 754-8:1998, which has been withdrawn.
To read about and order the other parts in this standard, visit www.bsigroup.com/aluminium