BS EN 62271-203:2004 - High-voltage switchgear and controlgear. Gas-insulated metal-enclosed switchgear for rated voltages above 52 kV

BS EN 62271-203:2004

High-voltage switchgear and controlgear. Gas-insulated metal-enclosed switchgear for rated voltages above 52 kV

Status : Superseded, Withdrawn   Published : May 2004 Replaced By : BS EN 62271-203:2012, BS EN 62271-202:2014, BS EN 62271-200:2012

WITHDRAWN TITLE
*To ask about withdrawn titles contact the
BSI Customer Services
cservices@bsigroup.com, +44 345 086 9001


Specifies requirements for gas-insulated, metal-enclosed switchgear in which the insulation is obtained, at least partly, by an insulating gas other than air at atmospheric pressure, for alternating current of rated voltages above 52 kV, for indoor and outdoor installation, and for service frequencies up to and including 60 Hz. For the purpose of this standard, the terms "GIS" and "switchgear" are used for "gas-insulated metal-enclosed switchgear". The gas-insulated metal-enclosed switchgear covered by this standard consists of individual components intended to be directly connected together and able to operate only in this manner. This standard completes and amends, if necessary, the various relevant standards applying to the individual components constituting GIS. This first edition of IEC 62271-203 cancels and replaces the third edition of IEC 60517, published in 1990, and constitutes a technical revision. With the revision, significant changes from the previous edition have been made. The most important changes are deleting not used technologies, like 3-phase PD measurements, adopting the content to IEC 62271-1 'Common Clauses' and harmonisation with IEEE C37.122. This standard is now more up to date to today's products on the world market. This International Standard should be read in conjunction with IEC 60694, second edition, published in 1996, its Amendment 1 (2000) and its Amendment 2 (2001), to which it refers and which is applicable unless otherwise specified.




Standard NumberBS EN 62271-203:2004
TitleHigh-voltage switchgear and controlgear. Gas-insulated metal-enclosed switchgear for rated voltages above 52 kV
StatusSuperseded, Withdrawn
Publication Date12 May 2004
Withdrawn Date01 October 2014
Normative References(Required to achieve compliance to this standard)EN 62155:2003, IEC 61672-1, EN 62271-100:2001, IEC 60859, IEC 61672-2, IEC 60141-1, EN 61672-2:2003, IEC 62271-102, EN 61672-1:2003, IEC 60068-2-11, EN 60044-1:1999, IEC 61462, EN ISO 3231:1997, IEC 60137, IEC 62155, IEC 60044-2, IEC 60044-1, EN 60044-2:1999, IEC 62271-100, EN 62271-102:2002, EN 60068-2-11:1999, IEC 61639, IEC 62067, EN 60137:1996, IEC 60840, IEC/TS 61462, ISO 3231
Informative References(Provided for Information)IEEE C37.122.1:1993, EN 50064:1990, IEEE C37.24:1986, EN 61264:1998, CIGRE 125:1998, IEEE 1416:1998, EN 50089:1992, EN 50052:1986, EN 50068:1991, EN 50069:1991
Replaced ByBS EN 62271-203:2012, BS EN 62271-202:2014, BS EN 62271-200:2012
ReplacesBS EN 60517:1997, IEC 60517:1990
International RelationshipsEN 62271-203:2004,IEC 60331-1:2009,IEC 62271-203:2003
Draft Superseded By01/200467 DC
DescriptorsElectric control equipment, Non-destructive testing, Verification, Leak tests, Dielectric-strength tests, Gases, Type testing, Short-circuit current tests, Circuits, Electrical equipment, Design, Marking, Rated voltage, Selection, Pressure testing, Rated frequencies, Relief valves, Endurance testing, Safety devices, Electric enclosures, Field testing, Artificial weathering tests, Temperature rise, Test equipment, Watertightness tests, Ratings, Electrical protection equipment, Type p protected electrical equipment, Electrical testing, Protected electrical equipment, Impulse-voltage tests, Earthing, Insulating enclosures, Thermal testing, Rated current, High-voltage equipment, Switchgear, Testing conditions
ICS13.220.40
29.020
29.060.20
29.130.10
Title in FrenchAppareillage a haute tension. Appareillage sous enveloppe metallique a isolation gazeuse de tensions assignees superieures a 52 kV
Title in GermanHochspannungs-Schaltgeraete und -Schaltanlagen. Gasisolierte metallgekapselte Schaltanlagen fuer Bemessungsspannungen von 52 kV und darueber
CommitteePEL/17
ISBN0 580 43767 1
PublisherBSI
FormatA4
DeliveryNo
Pages74
File Size1.024 MB
Price£274.00


WITHDRAWN TITLE
*To ask about withdrawn titles contact the
BSI Customer Services
cservices@bsigroup.com, +44 345 086 9001
 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


BSOL

The faster, easier way to work with standards


Develop a PAS

Develop a fast-track standardization document in 9-12 months