ASTM D705 - 99(2012) - Standard Specification for Urea-Formaldehyde Molding Compounds

Find Similar Items

This product falls into the following categories.

You may find similar items within these categories by selecting from the choices below:

ASTM D705 - 99(2012)

Standard Specification for Urea-Formaldehyde Molding Compounds

Status : Current   Published : January 2012



1.1 This specification covers compression molding thermosetting, urea-formaldehyde molding compounds as further defined in 3.1.

1.2 The values stated in SI units are to be regarded as the standard.

Note 1The properties included in this specification are those required to identify the types of molding compounds covered. There may be other requirements necessary to identify particular characteristics. Transfer or injection molding will usually result in different physical and electrical characteristics than compression molding.

1.3  The following safety hazards caveat pertains only to the test method portion, Section 7, of this specification:This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2ISO 2112-1977(E) is similar but not equivalent to this specification. Product classification and characterization are not the same.

Standard NumberASTM D705 - 99(2012)
TitleStandard Specification for Urea-Formaldehyde Molding Compounds
Publication Date12 January 2012
Descriptors Formaldehyde, Molding compounds (thermosetting), Urea-formaldehyde
File Size65 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


The faster, easier way to work with standards

Worldwide Standards
We can source any standard from anywhere in the world

27 November

Organizational Resilience Annual Conference 2019