OHSAS 18001:2007 - Occupational health and safety management systems. Requirements – BSI British Standards
Maintenance is taking place on Saturday 21st of October between 10am and 4pm BST during which time BSI Shop will be unavailable. Please accept our apologies for any inconvenience caused during this essential maintenance work. Please come back later and try again.

Find Similar Items

This product falls into the following categories.

You may find similar items within these categories by selecting from the choices below:

OHSAS 18001:2007

Occupational health and safety management systems. Requirements

Status : Current   Published : July 2007

Format
PDF

Format
HARDCOPY



For organizations operating outside of the UK

BS OHSAS 18001:2007 Occupational health and safety management systems.  Requirements specifies requirement for an occupational health and safety (OH&S) management system, to enable an organization to control its OH&S risks and improve its performance.

It does not state specific OH&S performance criteria, nor does it give detailed specifications for the design of a management system.

OHSAS 18001:2007 supersedes OHSAS 18001:1999, but remains current until 2009.

There have been a number of significant changes to the document since the first edition was published in 1999.

The changes reflect the widespread use and experience of the standard in more than 80 countries, and by approximately 16,000 certified organizations

Principal amongst the changes are much greater emphasis on "health" rather than just "safety", and significantly improved alignment to ISO 14001:2004 (to enable organizations to develop "integrated management systems").

Summary of key changes between OHSAS 18001:2007 and OHSAS 18001:1999

  • The importance of "health" has now been given greater emphasis.
  • OHSAS 18001 now refers to itself as a standard, not a specification, or document, as in the earlier edition. This reflects the increasing adoption of OHSAS 18001 as the basis for national standards on occupational health and safety management systems.
  • The "Plan-Do-Check-Act" model diagram is only given in the Introduction, in its entirety, and not also as sectional diagrams at the start of each major clause.
  • Reference publications in Clause 2 have been limited to purely international documents.
  • New definitions have been added, and existing definitions revised.
  • Significant improvement in alignment with ISO 14001:2004 throughout the standard; and improved compatibility with ISO 9001:2000.
  • A new requirement has been introduced for the consideration of the hierarchy of controls as part of OH&S planning
  • Management of change is now more explicitly addressed
  • A new clause on the "Evaluation of compliance" has been introduced, as per ISO 14001:2004
  • New requirements have been introduced for participation and consultation
  • New requirements have been introduced for the investigation of incidents

Other important information
For those organizations that have already achieved certification to OHSAS 18001:1999, or are in the final stages of achieving it, a two year "transition" period has been agreed, in order to allow them to make the change to using the new standard. The transition period will end on 1 July 2009. We do not believe that this will be a difficult process for such organizations.

For those organizations that are just starting down the path towards seeking certification to BS OHSAS 18001, and are looking for guidance to assist them, them we would recommend using the sister standard OHSAS 18002:2000 Occupational health and safety management systems - Guidelines for the implementation of OHSAS 18001. While this standard is aligned on a clause by clause basis against OHSAS 18001:1999, it does still contain valuable advice on what you need to do to achieve compliance. The OHSAS Project Group is about to start work to revise this standard, with a target of the end of the 3rd quarter of 2008 for publication of a revised edition.

Now available as a laminated pocketbook for better durability and portability

New

BS OHSAS 18002:2008 Occupational health and safety management systems. Guidelines for the implementation of BS OHSAS 18001:2007

 

Special offer
Book 3 conference places for the price of 2

Free copy of either BS OHSAS 18001 or BS OHS 18002!




Standard NumberOHSAS 18001:2007
TitleOccupational health and safety management systems. Requirements
StatusCurrent
Publication Date31 July 2007
DescriptorsOccupational safety, Health and safety management, Health and safety requirements, Environment (working), Management operations, Management, Planning, Policy formation, Policy, Hazards, Risk assessment, Personnel management, Personnel, Group communication, Training, Documents, Emergency measures, Performance, Records management, Records (documents), Quality auditing
ICS03.100.01
03.100.70
13.100
CommitteeHS/1
ISBN978 0 580 50802 8
PublisherBSI
DeliveryYes
Pages34
File Size307.4 KB
Price£50.00


 Your basket
Your basket is empty

Take the smart route to manage medical device compliance


BSOL

The faster, easier way to work with standards


Join us for the 10th anniversary Fire Safety Conference.


Worldwide Standards
We can source any standard from anywhere in the world


Customers who bought this product also bought