BS 1916-2:2009 Limits and fits for engineering. Guide to the selection of fits in BS 1916-1
BS 1916-2 gives guidance on the selection of fits given in BS 1916-1. The recommendations apply, in particular, to fits between cylindrical parts, designated as “holes” and “shafts”, in which case the term “size” refers to the diameter of the mating parts. The recommendations are also applicable to parts other than cylindrical, in which case the term “size” refers to a length, width or other dimension.
Tables of preferred sizes are included to avoid the indiscriminate selection of dimensions, and their use is strongly recommended.
Contents of BS 1916-2:
- Foreword
- Scope
- Normative references
- Terms and definitions
- Terminology
- Hole tolerances
- Classification of fits
- Choice of fit
- Choice of tolerance
- Preferred sizes
- Recommended tolerances for standard fits
- Bibliography
